Post-Processing

Post-process the simulation results by creating visualizations and measurements.

When you navigate to the Post ribbon, the model used for the pre-processing setup is cleared. To load a model for post-processing, open a log file from a completed AcuSolve run.
Attention: The icons shown on the ribbon below are used to complete this workflow. Click an icon to learn more about the tool.
Create Boundary Surface GroupsCreate StreamlinesCreate Slice PlanesCreate Iso-SurfacesGenerate Streamlines on SurfacesProbe ResultsCalculate Data from ExpressionsIntegrate Results on EntitiesCreate ClipsAdd NotesDetect Vortex CoresCreate 2D PlotsCalculate Engineering QuantitiesPerform General Signal Processing for Computational AeroacousticsPerform Ffwocs Williams and Hawkings (FW-H) Analysis for Computational Aeroacoustics